Cisco 6500 Series Software Configuration Manual page 466

Configuring PFC QoS
Table 31-3 Supported PFC QoS Data Export Facility Parameter Values (continued)
Name
auth
syslog
lpr
news
uucp
Table 31-4
Table 31-4 Supported PFC QoS Data Export Severity Parameter Values
Severity Parameter
Name
emerg
alert
crit
err
warning 4
notice
info
debug
This example shows how to configure 172.20.52.3 as the destination host and syslog as the UDP port
number and verify the configuration:
Router# configure terminal
Router(config)# mls qos statistics-export destination 172.20.52.3 syslog
Router(config)# end
Router# show mls qos statistics-export info
QoS Statistics Data Export Status and Configuration information
---------------------------------------------------------------
Export Status : enabled
Export Interval : 250 seconds
Export Delimiter : |
Export Destination : 172.20.52.3, UDP port 514 Facility local6, Severity debug
QoS Statistics Data Export is enabled on following ports:
---------------------------------------------------------
FastEthernet5/24
QoS Statistics Data export is enabled on following shared aggregate policers:
-----------------------------------------------------------------------------
aggr1M
QoS Statistics Data Export is enabled on following class-maps:
---------------------------------------------------------------
class3
Catalyst 6500 Series Switch Cisco IOS Software Configuration Guide—Release 12.1 E
31-76
Definition
security/authentication messages
internal syslogd messages
line printer subsytem
netnews subsytem
uucp subsystem
lists the supported PFC QoS data export severity parameter values.
Number Definition
0 system is unusable
1 action must be taken immediately
2 critical conditions
3 error conditions
warning conditions
5 normal but significant condition
6 informational
7 debug-level messages
Chapter 31
Name Definition
local3 reserved for local use
local4 reserved for local use
local5 reserved for local use
local6 reserved for local use
local7 reserved for local use
Configuring PFC QoS
78-14099-04