Configuring Nde; Configuring Nde On The Pfc - Cisco 6500 Series Software Configuration Manual

Configuring NDE

Configuring NDE
These sections describe how to configure NDE:
•
•
•
•
•
Note •
•
•

Configuring NDE on the PFC

These sections describe how to configure NDE on the PFC:
•
•
•
•
•
Enabling NDE From the PFC
NDE from the PFC uses the source configured for the MSFC. To enable NDE from the PFC, perform this
task:
Command
Router(config)# mls nde sender [version {5 | 7}]
Router(config)# no mls nde sender
With Supervisor Engine 1 and PFC, if NDE is enabled and you disable Multilayer Switching (MLS), you
Note
lose the statistics for existing cache entries. They are not exported when MLS shuts down.
Catalyst 6500 Series Switch Cisco IOS Software Configuration Guide—Release 12.1 E
33-8
Configuring NDE on the PFC, page 33-8
Configuring NDE on the MSFC, page 33-13
Displaying the NDE Address and Port Configuration, page 33-14
Configuring NDE Flow Filters, page 33-15
Displaying the NDE Configuration, page 33-17
You must enable NetFlow on the MSFC Layer 3 interfaces to support NDE on the PFC and on the
MSFC.
You must configure NDE on the MSFC to support NDE on the PFC.
With Release 12.1(11b)E and later releases, when you are in configuration mode you can enter
EXEC mode-level commands by entering the do keyword before the EXEC mode-level command.
Enabling NDE From the PFC, page 33-8
Setting the Minimum IP MLS Flow Mask, page 33-9
Populating Additional NDE Fields, page 33-10
Configuring the MLS Aging Time, page 33-10
Configuring Sampled NetFlow, page 33-11
Purpose
Enables NDE from the PFC.
NDE version 5 is supported on Supervisor Engine 2
Note
with Release 12.1(13)E and later releases.
Disables NDE from the PFC.
Chapter 33 Configuring NDE
78-14099-04