Cisco 6500 Series Software Configuration Manual page 465

Chapter 31 Configuring PFC QoS
This example shows how to set the PFC QoS statistics data export interval and verify the configuration:
Router(config)# mls qos statistics-export interval 250
Router(config)# end
Router# show mls qos statistics-export info
QoS Statistics Data Export Status and Configuration information
---------------------------------------------------------------
Export Status : enabled
Export Interval : 250 seconds
Export Delimiter : |
Export Destination : Not configured
QoS Statistics Data Export is enabled on following ports:
---------------------------------------------------------
FastEthernet5/24
QoS Statistics Data export is enabled on following shared aggregate policers:
-----------------------------------------------------------------------------
aggr1M
QoS Statistics Data Export is enabled on following class-maps:
---------------------------------------------------------------
class3
Router#
Configuring PFC QoS Statistics Data Export Destination Host and UDP Port
To configure the PFC QoS statistics data export destination host and UDP port number, perform this task:
Command
Step 1
Router(config)# mls qos statistics-export
destination {host_name | host_ip_address}
{port port_number | syslog
[facility facility_name]
[severity severity_value]}
Router(config)# no mls qos statistics-export
destination
Step 2
Router(config)# end
Step 3
Router# show mls qos statistics-export info
When the PFC QoS data export destination is a syslog server, the exported data is prefaced with a syslog
Note
header.
Table 31-3
Table 31-3 Supported PFC QoS Data Export Facility Parameter Values
Name
kern
user
mail
daemon
78-14099-04
lists the supported PFC QoS data export facility and severity parameter values.
Definition
kernel messages
random user-level messages
mail system
system daemons
Catalyst 6500 Series Switch Cisco IOS Software Configuration Guide—Release 12.1 E
Purpose
Configures the PFC QoS statistics data export destination
host and UDP port number.
Clears configured values.
Exits configuration mode.
Verifies the configuration.
Name Definition
cron cron/at subsystem
local0 reserved for local use
local1 reserved for local use
local2 reserved for local use
Configuring PFC QoS
31-75