Cisco 6500 Series Software Configuration Manual page 42

Configuring the Switch
GigabitEthernet1/1
GigabitEthernet1/2
GigabitEthernet3/1
GigabitEthernet3/2
GigabitEthernet3/3
GigabitEthernet3/4
GigabitEthernet3/5
GigabitEthernet3/6
GigabitEthernet3/7
GigabitEthernet3/8
<...output truncated...>
Choose which protocols to support on your interfaces. On IP installations only, you can accept the
Step 3
default values for most of the questions.
A typical minimal configuration using IP follows and continues through
Configuring global parameters:
Enter host name [Router]: Router
Enter the enable secret password when the following is displayed (remember this password for future
Step 4
reference):
The enable secret is a password used to protect access to
privileged EXEC and configuration modes. This password, after
entered, becomes encrypted in the configuration.
Enter enable secret: barney
Step 5 Enter the enable password when the following is displayed (remember this password for future
reference):
The enable password is used when you do not specify an
enable secret password, with some older software versions, and
some boot images.
Enter enable password: wilma
The commands available at the user EXEC level are a subset of those available at the privileged EXEC
level. Because many privileged EXEC commands are used to set operating parameters, you should
protect these commands with passwords to prevent unauthorized use.
You must enter the correct password to gain access to privileged EXEC commands. When you are
running from the boot ROM monitor, the enable password might be the correct one to use, depending on
your boot ROM level.
The enable and enable secret passwords need to be different for effective security. You can enter the same
password for both enable and enable secret during the setup script, but you receive a warning message
indicating that you should enter a different password.
Catalyst 6500 Series Switch Cisco IOS Software Configuration Guide—Release 12.1 E
3-6
172.20.52.34 YES NVRAM
unassigned YES TFTP
unassigned YES TFTP
unassigned YES TFTP
unassigned YES TFTP
unassigned YES TFTP
unassigned YES TFTP
unassigned YES TFTP
unassigned YES TFTP
unassigned YES TFTP
Chapter 3 Configuring the Switch for the First Time
up
administratively down down
administratively down down
administratively down down
administratively down down
administratively down down
administratively down down
administratively down down
administratively down down
administratively down down
Step 8:
up
78-14099-04