Default Ip Mls Configuration; Ip Mls Configuration Guidelines And Restrictions; Configuring Ip Mls; Enabling Ip Mls Globally - Cisco 6500 Series Software Configuration Manual

Default IP MLS Configuration

Default IP MLS Configuration
Table 19-1
Table 19-1 Default IP MLS Configuration
Feature
IP MLS enable state
IP MLS aging time
IP MLS fast aging time
IP MLS fast aging-time packet threshold
IP MLS long aging time

IP MLS Configuration Guidelines and Restrictions

Follow these guidelines and restrictions when configuring IP MLS:
•
•
•

Configuring IP MLS

These sections describe how to configure the MSFC for IP MLS:
•
•
•
•
•
The MSFC can be specified as the MLS route processor (MLS-RP) for Catalyst 5000 family switches
Note
using MLS. Refer to the Layer 3 Switching Configuration Guide—Catalyst 5000 Family, 4000 Family,
2926G Series, 2926 Series, and 2948G for procedures.
With Release 12.1(11b)E and later, when you are in configuration mode you can enter EXEC mode-level
Note
commands by entering the do keyword before the EXEC mode-level command.

Enabling IP MLS Globally

IP MLS is enabled globally and cannot be disabled.
Catalyst 6500 Series Switch Cisco IOS Software Configuration Guide—Release 12.1 E
19-6
shows the default IP MLS configuration.
The clear ip route command clears all IP MLS cache entries.
The no ip routing command purges all IP MLS cache entries and disables IP MLS.
The ip security interface command disables IP MLS on the interface.
Enabling IP MLS Globally, page 19-6
Disabling and Enabling IP MLS on a Layer 3 Interface, page 19-7
Displaying the Interface IP MLS Configuration, page 19-7
Configuring the MLS Aging-Time, page 19-8
Setting the Minimum IP MLS Flow Mask, page 19-8
Chapter 19 Configuring IP Unicast Layer 3 Switching on Supervisor Engine 1
Default Value
Enabled
256 seconds
32 seconds
100 packets
900 seconds
78-14099-04