Configuring The Minimum Ipx Mls Flow Mask; Displaying Ipx Mls Information - Cisco 6500 Series Software Configuration Manual

Displaying IPX MLS Information

Configuring the Minimum IPX MLS Flow Mask

You can configure the minimum granularity of the flow mask for the MLS cache on the PFC. The actual
flow mask used will be at least of the granularity specified by this command. For information on how
the different flow masks work, see the
This command purges all existing shortcuts in the MLS cache and affects the number of active shortcuts
Caution
on the PFC. Be careful when using this command.
To configure the minimum IPX MLS flow mask, perform this task:
Command
Router(config)# mls flow ipx {destination |
destination-source}
Router(config)# no mls flow ipx
This example displays how to configure the minimum IPX MLS flow mask to destination:
Router(config)# mls flow ipx destination
Router(config)#
To display the IPX MLS flow mask configuration, perform this task:
Command
Router# show mls flowmask
This example displays the MLS flow mask configuration:
Router# show mls flowmask
current ip flowmask for unicast: destination only
current ipx flowmask for unicast: destination only
Displaying IPX MLS Information
This section describes the commands used to display IPX MLS configuration and statistics for the switch
and the various interfaces and is separated into the following:
•
•
•
Catalyst 6500 Series Switch Cisco IOS Software Configuration Guide—Release 12.1 E
20-8
Displaying IPX MLS Cache Entries, page 20-9
Displaying the IPX MLS Contention Table, page 20-11
Displaying IPX MLS VLAN Statistics, page 20-12
Chapter 20 Configuring IPX Unicast Layer 3 Switching on Supervisor Engine 1
"Flow Masks" section on page
Purpose
Configures the minimum IPX MLS flow mask.
Reverts to the default IPX MLS flow mask.
Purpose
Displays the flow mask configuration.
20-3.
78-14099-04