Default Ipx Mls Configuration; Configuration Guidelines And Restrictions - Cisco 6500 Series Software Configuration Manual

Chapter 20 Configuring IPX Unicast Layer 3 Switching on Supervisor Engine 1
Figure 20-1 IPX MLS Example Topology
MAC = Aa
Host A
Data

Default IPX MLS Configuration

Table 20-1
Table 20-1 Default IPX MLS Configuration
Feature
IPX MLS enable state
IPX MLS aging time
IPX MLS fast aging time
IPX MLS fast aging time packet threshold
IPX MLS long aging time

Configuration Guidelines and Restrictions

•
78-14099-04
Source IPX Destination
Address IPX Address
01.Aa 03.Bb
01.Aa 02.Cc
02.Cc 01.Aa
Net 1/Sales
01
01.Aa:02.Cc Aa:Dd
displays the default IPX MLS configuration.
These Cisco IOS software features and commands affect IPX MLS:
IPX accounting—IPX accounting cannot be enabled on an IPX MLS-enabled interface.
–
– IPX EIGRP—MLS is supported for EIGRP interfaces if the Transport Control (TC) maximum
is set to a value greater than the default (16).
The clear ipx route command clears all IPX MLS cache entries.
–
Catalyst 6500 Series Switch Cisco IOS Software Configuration Guide—Release 12.1 E
Rewrite Src/Dst Destination
MAC Address VLAN
Dd:Bb Marketing
Dd:Cc Engineering
Dd:Aa Sales
MAC = Dd
MSFC
Data
Default Value
Enabled
256 seconds
32 seconds
100 packets
900 seconds
Default IPX MLS Configuration
MAC = Bb
Host B
MAC = Cc
Host C
01.Aa:02.Cc Dd:Cc
20-5