Configuring Inline Power Support - Cisco 6500 Series Software Configuration Manual

Configuring Cisco IP Phone Support

Configuring Inline Power Support

To configure inline power support, perform this task:
Command
Step 1
Router(config)# interface fastethernet slot/port
Step 2
Router(config-if)# power inline {auto | never}
Router(config-if)# no power inline
Step 3
Router(config)# end
Step 4
Router# show power inline
[fastethernet slot/port]
When configuring inline power support, note the following syntax information:
•
•
This example shows how to disable inline power on Fast Ethernet port 5/1:
Router# configure terminal
Router(config)# interface fastethernet 5/1
Router(config-if)# power inline never
This example shows how to enable inline power on Fast Ethernet port 5/1:
Router# configure terminal
Router(config)# interface fastethernet 5/1
Router(config-if)# power inline auto
This example shows how to verify the inline power configuration on Fast Ethernet port 5/1:
Router# show power inline fastethernet 5/1
Interface
---------- ----- ---------- ------- -------------------
Fa5/1
Catalyst 6500 Series Switch Cisco IOS Software Configuration Guide—Release 12.1 E
11-8
To configure auto-detection of a Cisco IP Phone, enter the auto keyword.
To disable auto-detection of a Cisco IP Phone, enter the never keyword.
Admin Oper
auto on
Purpose
Selects the port to configure.
Configures inline power support.
Clears the configuration.
Exits configuration mode.
Verifies the configuration.
Power Device
(Watts)
6.3 cisco phone device
Chapter 11 Configuring Cisco IP Phone Support
78-14099-04