Clearing Ip Multicast Layer 3 Switching Statistics - Cisco 6500 Series Software Configuration Manual

Chapter 18 Configuring IP Multicast Layer 3 Switching
Table 18-2 IP Multicast Layer 3 Switching Debug Commands (continued)
Command
[no] debug mls ip multicast group group_id
group_mask
[no] debug mls ip multicast messages
[no] debug mls ip multicast all
[no] debug mdss errors
[no] debug mdss events
[no] debug mdss all
1. MDSS = Multicast Distributed Switching Services

Clearing IP Multicast Layer 3 Switching Statistics

To clear IP multicast Layer 3 switching statistics, perform this task:
Command
Router# clear mls ip multicast statistics
This example shows how to clear IP multicast Layer 3 switching statistics:
Router# clear mls ip multicast statistics
The show mls multicast statistics command displays a variety of information about the multicast flows
being handled by the PFC. You can display entries based on any combination of the participating MSFC,
the VLAN, the multicast group address, or the multicast traffic source. For an example of the show mls
ip multicast statistics command, see the
on page
78-14099-04
18-17.
Catalyst 6500 Series Switch Cisco IOS Software Configuration Guide—Release 12.1 E
Configuring IP Multicast Layer 3 Switching
Description
Turns on debugging for a subset of flows.
Displays IP multicast Layer 3 switching messages from and to
hardware switching engine.
Turns on all IP multicast Layer 3 switching messages.
1
Turns on MDSS error messages.
Turns on MDSS-related events.
Turns on all MDSS messages.
Purpose
Clears IP multicast Layer 3 switching statistics.
"Displaying IP Multicast Layer 3 Switching Statistics" section
18-19