Cisco 6500 Series Software Configuration Manual page 21

Preface
This preface describes who should read the Catalyst 6500 Series Switch Cisco IOS Software
Configuration Guide, how it is organized, and its document conventions.
Audience
This guide is for experienced network administrators who are responsible for configuring and
maintaining Catalyst 6500 series switches.
Organization
This guide is organized as follows:
Chapter
Chapter 1
Chapter 2
Chapter 3
Chapter 4
Chapter 5
Chapter 6
Chapter 7
Chapter 8
Chapter 9
Chapter 10
78-14099-04
Title
Product Overview
Command-Line Interfaces
Configuring the Switch for the
First Time
Configuring EHSA Supervisor
Engine Redundancy
Configuring RPR and RPR+
Supervisor Engine Redundancy
Configuring Interfaces
Configuring LAN Ports for Layer
2 Switching
Configuring VTP
Configuring VLANs
Configuring Private VLANs
Catalyst 6500 Series Switch Cisco IOS Software Configuration Guide—Release 12.1 E
Description
Presents an overview of the Catalyst 6500 series
switches.
Describes how to use the command-line interface
(CLI).
Describes how to perform a baseline configuration.
Describes how to configure EHSA supervisor engine
redundancy.
Describes how to configure RPR and RPR+
supervisor engine redundancy.
Describes how to configure non-layer-specific
features on LAN interfaces.
Describes how to configure LAN interfaces to
support Layer 2 features, including VLAN trunks.
Describes how to configure the VLAN Trunking
Protocol (VTP).
Describes how to configure VLANs.
Describes how to configure private VLANs.
21