Develop ineo+ 25 User Manual page 301

This message...
COMMUNICATION ERROR
USB Memory
COMMUNICATION ERROR
xxx Server
DISCONNECT
USB Memory
DISCONNECT
xxx Server
Fuser Unit Life
I-UNIT END
REPLACE x
I-Unit End x
I-Unit Life (x)
I-Unit Low x
Status, Error, and Service Messages
means...
While data was
being sent in Scan
mode, the connec-
tion to the USB
memory device was
interrupted.
While data was
being sent in Scan
mode, the connec-
tion to the server
was interrupted.
The connection to
the USB memory
device was inter-
rupted.
The connection to
the server was
interrupted.
The time to replace
the fuser unit has
been reached.
The time to replace
the indicated imag-
ing unit has been
reached.
The time to replace
the indicated imag-
ing unit has been
reached.
The time to replace
the indicated imag-
ing unit has been
reached.
The indicated imag-
ing unit is low and
should be replaced
within 200 pages at
5% coverage of
Letter/A4 paper.
Do this...
Check the connection
to the USB memory
device, and then try
sending the data
again.
Check the settings in
the [NETWORK SET-
TING] menu, and then
try sending the data
again.
Check the connection
to the USB memory
device, and then try
sending the data
again.
Check the settings in
the [NETWORK SET-
TING] menu, and then
try connecting again.
Replace the fuser unit.
Replace the indicated
imaging unit.
Replace the indicated
imaging unit.
Replace the indicated
imaging unit.
Prepare the indicated
imaging unit.
10-41