Chapter 3 Cnf(16)-U20 Etu Configuration; Configuring The Cnf(16)-U20 Etu; Configuring The Pc - NEC ElectraElite IPK II Installation Manual

C h a p t e r 3
___________________________________________________________________________________
S 1
ECTION
C
When installed for the first time, the CNF(16)-U20 ETU comes up with the factory
default parameters shown in
In this configuration, the ETU cannot run in every environment.
parameters must be defined again before it can work in your environment. The
required parameters can be set using your web browser and connecting to default IP
address 192.168.1.100 in the browser navigation address bar.

S 2 C
ECTION
After the Multilmedia Conference Bridge is installed in the KSU, the PC that is
communicating with the CNF(16)-U20 ETU must be configured to recognize the CNF
ETU. The PC and CNF ETU must be connected using a straight ethernet cable,
crossover cable, and/or a small hub. To ensure proper communication between the
PC and the CNF ETU, they must be attached to the same network.
To configure the PC:
1.
___________________________________________________________________________________
Multimedia Conference Bridge Installation Manual
CNF(16)-U20 ETU Configuration
O N F I G U R I N G T H E
Table 3-1 Network Settings for TCP/IP Addressing
IP Address
Subnet Mask
Default Gateway
Internet Explorer 6.0 or higher is recommended.
PC
ONFIGURING THE
Press Start and select Control Panel from the menu.
 Windows XP Professional operating system is used in this example. When using
a different Windows operating system, the screens may look slightly different.
C N F ( 1 6 ) - U 2 0 E T U
Table 3-1 Network Settings for TCP/IP
192.168.1.100
255.255.255.0
0.0.0.0
Addressing.
Therefore, its
3 - 1