Advanced Settings; Inverter Data - Ingeteam Ingecon Sun 1Play HF Installation And Usage Manual

Display control
Date and time
Languages
Modbus ID
Partial deletion
Grounding
Contrast
String settings
Power settings
Fan test
Self-consumption
Factory reset
Auxiliary relay closure

13.6.5. Advanced settings

The settings included within this menu can only be modified by a qualified installer.
Ingeteam accepts no liability for incorrect use of the installer password nor the consequences that
may arise from incorrect configuration of the unit by the user and/or the installer.
To modify the parameters of this menu the installer password will be requested.
The installer password is 3725.
Within this menu you can change the password, adjust the voltage and frequency values or modify the country and
the regulations applicable to the inverter.

13.6.6. Inverter data

From this menu you can consult different data referring to the inverter.
ABF2011IQE01_A - Installation and usage manual
To modify the date and time of the inverter.
Selection of the language for the text on the inverter display.
Assignation of a number that identifies the inverter. In PV installations with more than
one inverter, each one must be assigned a different number. Ingeteam recommends
using correlative numbering.
Deletes the partial meters.
From this menu you can configure the PV array grounding. In addition to this
configuration, you must make the connections indicated in section "9. Connection of the
ground connection".
To adjust the screen contrast of the inverter.
Not applicable.
Reduce the unit power.
By accessing this option it is possible to run a test to check the inverter fans are working
properly.
With this menu you can configure the Self-consumption mode.
This returns the inverter to factory default status.
Selection of the reason the auxiliary relay closes. The selectable reasons are: insulation
fault, Vac and Fac out of range values, connected to grid or external load.
Ingeteam
37