Removing The Virtual Media Key; Installing The Virtual Media Key - IBM System x3550 M3 Type 4254 Problem Determination And Service Manual

5. Insert the fan into the fan slot in the fan assembly bracket and press it down
6. Install the cover (see "Installing the cover" on page 174).
7. Slide the server into the rack.

Removing the virtual media key

To remove the virtual media key, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices and disconnect all power cords; then,
3. Grasp the virtual media key and gently slide it up and off of the mounting tab.
4. If you are instructed to return the virtual media key, follow all packaging

Installing the virtual media key

To install the virtual media key, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Remove the cover (see "Removing the cover" on page 174).
3. Align the virtual media key with the mounting tab and slide it down the tab onto
216
IBM System x3550 M3 Types 4254 and 7944: Problem Determination and Service Guide
until it is seated correctly in the slot and the fan connector is seated correctly in
the connector on the system board.
on page 167.
remove the cover (see "Removing the cover" on page 174).
instructions, and use any packaging materials for shipping that are supplied to
you.
on page 167.
the connector on the system board. Press the virtual media key down into the
connector until it is firmly seated on the system board.