Removing a simple-swap hard disk drive
Attention:
power from the server before removing or installing a simple-swap hard disk drive.
To remove a simple-swap hard disk drive, complete the following steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and all attached devices; then, disconnect all power cords
3. Unlock the side cover.
4. Remove the side cover (see "Removing the side cover" on page 78).
5. Remove the bezel (see "Removing the bezel" on page 76).
6. Pull the loops of the drive assembly that is to be removed toward each other;
7. If you are instructed to return the drive assembly, follow all packaging
92
ThinkServer TD100 and TD100x: Hardware Maintenance Manual
Simple-swap hard disk drives are not hot-swappable. Disconnect all
on page 73.
and external cables.
then, pull the assembly out of the bay.
instructions, and use any packaging materials for shipping that are supplied to
you.