Removing The Side Cover - Lenovo ThinkServer TD100 Hardware Maintenance Manual

Removing the side cover

Attention:
removed might damage server components. For proper cooling and airflow, replace
the side cover before turning on the server.
To remove the side cover, complete the following steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. If you are replacing a non-hot-swap component, turn off the server and all
3. Unlock the side cover.
4. Press the cover-release latch down, as indicated by the two arrows on the latch,
5. Lift the side cover off the server and set it aside.
6. If you are instructed to return the side cover, follow all packaging instructions,
78
ThinkServer TD100 and TD100x: Hardware Maintenance Manual
Operating the server for more than 30 minutes with the side cover
1
Left-side cover
2
Lock
3
Cover release latch
on page 73.
attached devices; then, disconnect all power cords and external cables.
and tilt the top of the side cover away from the chassis.
and use any packaging materials for shipping that are supplied to you.