Installing The Hot-Swap Power-Supply Cage Assembly - Lenovo ThinkServer TD100 Hardware Maintenance Manual

Installing the hot-swap power-supply cage assembly

To install the hot-swap power-supply cage assembly, complete the following steps.
1. Align the screw holes on the power-supply cage 1 pivot bracket with the
2. Press the power-supply cage release tab 1 and rotate the power-supply cage
corresponding screw holes on the rear of the chassis. Support the cage while
you install the three screws 2 to secure the pivot bracket on the power-supply
cage to the chassis.
assembly into the chassis until it locks in place.
Chapter 4. Removing and replacing server components
127