Lenovo ThinkServer TD100 Hardware Maintenance Manual page 210

v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v See Chapter 3, "Parts listing, TD100 Types 6398, 6399, 6419, 6429, 4203, and 4206," on page 25 to
determine which components are customer replaceable units (CRU) and which components are field
replaceable units (FRU).
v If an action step is preceded by "(Trained service technician only)," that step must be performed only by a
trained service technician.
Error code Description
001-292-000 Core system: failed/CMOS checksum failed. Load the BIOS default settings by using the
005-xxx-000 Failed video test.
011-xxx-000 Failed COM1 serial port test.
015-xxx-001 Failed USB test.
015-xxx-198 Remote Supervisor Adapter II SlimLine
installed or USB device connected during
USB test.
020-xxx-000 Failed PCI Interface test.
030-265-001 Communication Error.
030-266-001 A SAS/SATA Channel Error.
192
ThinkServer TD100 and TD100x: Hardware Maintenance Manual
Action
Configuration/Setup Utility program, and run the test
again (see "Using the Configuration/Setup Utility
program" on page 16).
1. Reseat the video adapter, if one is installed.
2. (Trained service technician only) Replace the
system board.
1. Check the loopback plug that is connected to the
externalized serial port.
2. Check the cable from the externalized serial port
to the system board.
3. (Trained service technician only) Replace the
system board.
(Trained service technician only) Replace the system
board.
1. If a Remote Supervisor Adapter II SlimLine is
installed as an option, remove it and run the test
again.
2. Remove all USB devices and run the test again.
3. (Trained service technician only) Replace the
system board.
1. Reseat the PCI, PCI-X, or PCI Express adapter.
2. Replace the following components one at a time,
in the order shown, restarting the server each
time:
a. Adapter
b. (Trained service technician only) System
board
1. Update the microcode for the Serial Attached
SCSI (SAS)/SATA controller (see "Updating the
firmware" on page 15).
2. Update the BIOS code (see "Updating the
firmware" on page 15).
3. (Trained service technician only) Replace the
system board.
1. Update the microcode for the onboard Serial
Attached SCSI (SAS)/SATA controller (see
"Updating the firmware" on page 15).
2. Update the BIOS code (see "Updating the
firmware" on page 15).
3. (Trained service technician only) Replace the
system board.