Installing A Sata Hard Drive - Nexcom VTC 6200 User Manual

Chapter 3: System Setup

Installing a SATA Hard Drive

1. The metal bracket is used to hold a SATA hard drive. First, remove the
screws that secure the metal bracket to the board then remove the
bracket.
If you intend to install a Mini PCI Express module or a bluetooth
module, please install these devices first before proceeding to
the next step. Refer to their respective sections in this chapter for
instructions on installing a Mini PCI Express module or a bluetooth
module.
Copyright © 2011 NEXCOM International Co., Ltd. All rights reserved
2. Position the HDD brackets on each side of the SATA drive. Align the
mounting holes that are on the sides of the SATA drive with the HDD
brackets' mounting screws.
Metal
bracket
48
HDD bracket
SATA drive
Mounting
screws
VTC 6200 / VTC 6200-NI / VTC 6200-NI-DK User Manual