Completing The Installation - IBM 8038 Installation And User Manual

To install a storage interface card, complete the following steps:
1. Before you begin, read "Safety" on page v and "Installation guidelines" on
2. If the blade server is installed in a BladeCenter unit, remove it (see "Removing
3. Remove the blade server cover (see "Removing the blade server cover" on page
4. If an optional expansion unit is installed, remove the expansion unit (see
5. Locate the CIOv expansion connector (see "Blade server connectors" on page
6. Touch the static-protective package that contains the storage interface card to
7. Orient the connector on the storage interface card with the CIOv expansion
8. Firmly press on the indicated locations to seat the storage interface card.
9. If you have other devices to install or remove, do so now; otherwise, go to

Completing the installation

To complete the installation, complete the following tasks.
1. Reinstall the optional expansion unit, if you removed one to install other
2. Close the blade server cover, unless you installed an optional expansion unit
page 17.
the blade server from the BladeCenter unit" on page 19 for instructions).
20 for instructions).
"Removing an optional expansion unit" on page 23).
15).
any unpainted metal surface on the BladeCenter unit or any unpainted metal
surface on any other grounded rack component; then, remove the storage
interface card from the package.
connector on the system board; then, press the storage interface card into the
CIOv expansion connector.
Note: For device-driver and configuration information to complete the
installation of the expansion card, see the documentation that comes with the
storage interface card.
"Completing the installation."
devices (see "Installing an optional expansion unit" on page 21 for information
on installing the expansion unit).
that has its own cover (see "Installing the blade server cover" on page 44).
Statement 21
Chapter 3. Installing options
43