Troubleshooting - Xterra 1644980US Owner's Manual

Troubleshooting

I. Engineering Mode
Pull off the safety key and reinsert it after pressing "PROGRAM" button to enter engineering mode.
Press "SET" button to choose setting wheel size, minimum speed, maximum speed or maximum
incline level. Press SPEED+ or SPEED- to change the value. Press "START" when finish. The
treadmill starts to calibrate and to exit when calibration is finished.
II. What to do when error occurs
1. E0: Safety key is not inserted
2. E1: Missing speed signal
To clear: Check and make sure that speed signal connector is properly connected.
3. E2: Overloaded
To clear: Resume power to the controller to clear the error message.
4. E3: Incline motor error
To clear: Check and make sure that the incline motor cable is properly connected and
resume power to clear error message.
5. E4: Motor error
To clear: Check and make sure that motor cable is well connected and the power is stable.
Resume power to clear error message.
6. E5: communication disconnection
To clear: Check and make sure that cable connections are proper.
7. E6: Insufficient of power
To clear: Check if voltage is too low or power transistor has been damaged. Replace power
transistor if necessary.
Customer Service 1-888-707-1880
Email: customerservice@dyaco.ca
30
Dyaco Canada Inc. 2014