Reset Switch Resetting; Speed Sensor Adjustment - Xterra 1644980US Owner's Manual

RESET SWITCH RESETTING

If your treadmill looses power or will not start, check the reset switch located on the front
of the motor cover.
If the white tab of the reset switch is not showing then the reset switch has not been
tripped.
If the white tab of the reset switch is showing, the reset switch has tripped.
To reset the reset switch:
Remove the safety clip on console.
Press white tab of the reset switch in until it snaps back into place.
If the reset switch continues to trip - see treadbelt adjustment and treadbelt lubrication

SPEED SENSOR ADJUSTMENT

If the monitor does not display speed or distance the speed sensor and magnet may be
misaligned.
Note: Always unplug your treadmill prior to cleaning in order to avoid electrical
hazard or shock.
Follow these steps to check and realign.
Remove the motor cover
Check the spacing and alignment between the magnet on the right side of the front roller
and the speed sensor on the frame. The spacing must be 1/8".
Loosen screw and slide speed sensor in or out of clamp.
Retighten screw and replace the motor cover.
28
Customer Service 1-888-707-1880 Dyaco Canada Inc. 2014
Email: customerservice@dyaco.ca