User Preferences Parameter Defaults - Motorola Symbol DS3407 Product Reference Manual

User Preferences Parameter Defaults

Table 4-1 lists defaults for user preferences parameters. There are two ways to change the default values:
•
Scan the appropriate bar codes in this guide. These new values replace the standard default values in
memory. To recall the default parameter values, scan the
•
Download data through the device's serial port using SSI. Hexadecimal parameter numbers appear in this
chapter below the parameter title, and options appear in parenthesis beneath the accompanying bar codes.
See the Simple Serial Interface (SSI) Programmer's Guide for detailed instructions for changing parameters
using this method.
NOTE See
miscellaneous default parameters.
User Preferences Default Table
Table 4-1
Parameter
User Preferences
Set Default Parameter
Parameter Scanning
Beeper Tone
Beeper Volume
Power Mode
Time Delay to Low Power Mode
Trigger Mode
Picklist Mode
Decode Session Timeout
Timeout Between Decodes, Same Symbol
Beep After Good Decode
Fuzzy 1D Processing
Decode Mirror Images
Scanstand Session Timeout
Appendix A, Standard Default Parameters
*Set All Defaults
for all user preferences, hosts, symbologies, and
Parameter
Number
All Defaults
ECh Enable
91h Medium
8Ch High
80h Continuous On
92h 5 Minutes
8Ah Auto Aim
F0h 92h Disabled Always
Aim Dot only: Enabled Always
88h 9.9 Sec
89h 0.6 Sec
38h Enable
F1h, 02h Enable
F1h, 19h Never
F0h, 90h 2 Seconds
User Preferences
bar code on page 4-4.
Page
Default
Number
4-4
4-4
4-5
4-6
4-6
4-7
4-8
4-9
4-10
4-10
4-11
4-11
4-12
4-12
4 - 3