Scanning Sequence Examples; Errors While Scanning; User Preferences/Miscellaneous Options Parameter Defaults - Motorola DS9208 Product Reference Manual

4 - 2 DS9208 Product Reference Guide

Scanning Sequence Examples

In most cases, scanning one bar code sets the parameter value. For example, to set the beeper tone to high,
scan the High Frequency (beeper tone) bar code listed under
issues a fast warble beep and the LED turns green, signifying a successful parameter entry.
Other parameters, such as Serial Response Timeout or Data Transmission Formats, require scanning
several bar codes. See these parameter descriptions for this procedure.

Errors While Scanning

Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.

User Preferences/Miscellaneous Options Parameter Defaults

Table 4-1 lists defaults for user preferences parameters. To change the default values, scan the appropriate
bar codes in this guide. These new values replace the standard default values in memory. To recall the default
parameter values, scan the
NOTE See
miscellaneous default parameters.
User Preferences Parameter Defaults
Table 4-1
User Preferences
Set Default Parameter
Parameter Bar Code Scanning
Beep After Good Decode
Beeper Tone
Beeper Volume
Volume Adjustment Trigger Timeout
Beeper Duration
Suppress Power-up Beeps
Low Power Mode
Time Delay to Low Power Mode
Trigger Mode
Trigger Aiming Pattern
Presentation Aiming Pattern
Momentary Trigger Mode Timeout
Motion Detect Range
Set Default Parameter on page
Appendix A, Standard Default Parameters
Parameter
Beeper Tone on page
4-5.
for all user preferences, hosts, symbologies, and
Parameter
Number
Set Defaults
ECh Enable
38h Enable
91h Medium
8Ch High
F0h 93h 5.0 Sec
F1h 74h Medium
F1h D1h Do not suppress
80h Disable
92h 1 Hour
8Ah Presentation
F0h 32h Enable
F1h 4Eh Disable
EDh 5 sec
F2h 3Bh Full
4-7. The digital scanner
Page
Default
Number
4-5
4-6
4-6
4-7
4-8
4-9
4-10
4-10
4-11
4-12
4-14
4-15
4-16
4-17
4-18