Removing The Interface Cable; Connecting Power (If Required); Configuring The Digital Scanner - Motorola Symbol DS3407 Product Reference Manual
Motorola symbol ds3407 barcode scanner product reference guide
Hide thumbs
Also See for Symbol DS3407:
- Reference manual (404 pages) ,
- Quick start manual (3 pages) ,
- Quick start manual (2 pages)
Table of Contents
Advertisement
1 - 4
Symbol DS3407 Product Reference Guide
Close the clamp, push it back into place and tighten the screws on the clamp to secure the cable into the
4.
bottom of the digital scanner.
Securing the Clamp
Figure 1-4
Connect the other end of the interface cable to the host (see the specific host chapter for information on host
5.
connections).
NOTE Different hosts require different cables. The connectors illustrated in each host chapter are examples only.
The connectors may be different than those illustrated, but the steps to connect the digital scanner are the
same.
Removing the Interface Cable
Loosen the two screws on the cable clamp at the bottom of the digital scanner and gently pull the clamp away
1.
from the bottom of the digital scanner.
Open the clamp and unplug the interface cable modular connector from the cable interface port on the bottom
2.
of the digital scanner handle. Carefully slide out the cable.
Follow the steps for
3.
Connecting Power (if required)
If the host does not provide power to the digital scanner, connect an external power supply to the digital scanner:
Connect the interface cable to the bottom of the digital scanner, as described in
1.
on page
1-3.
Connect the other end of the interface cable to the host (refer to the host manual to locate the correct port).
2.
Plug the power supply into the power jack on the interface cable. Plug the other end of the power supply into
3.
an AC outlet.
Configuring the Digital Scanner
To configure the digital scanner, use the bar codes in this manual, or the 123Scan configuration program.
See
Chapter 4, User Preferences
Also see each host-specific chapter to set up connection to a specific host type.
See
Chapter 9, 123 Scan
help file.
Installing the Interface Cable on page 1-3
for information about programming the digital scanner using bar code menus.
to configure the digital scanner using this configuration program. This program includes a
to connect a new cable.
Installing the Interface Cable
Advertisement
Table of Contents
