Motorola Symbol DS3407 Product Reference Manual page 25
Motorola symbol ds3407 barcode scanner product reference guide
Hide thumbs
Also See for Symbol DS3407:
- Reference manual (404 pages) ,
- Quick start manual (3 pages) ,
- Quick start manual (2 pages)
Table of Contents
Advertisement
Beeper Definitions (Continued)
Table 2-1
Beeper Sequence
4 long low beeps
5 long low beeps
Fast warble beep
Low/High beeps
ADF Programming: Normal Data Entry. Duration of tones are short.
High/Low beeps
Low/Low beeps
High/High beeps
High/Low/High/Low beeps
High/Low/Low beeps
Low beep
Low/High/High beeps
ADF Programming: Error Indications. Duration of tones are very long.
Low/High/Low/High beeps
Low/High/Low beeps
Low/High beeps
Host Specific
USB only
4 short high beeps
Short low/short medium/short high
beep sequence after scanning a USB
device type
Short low/short medium/short high
beep sequence occurs more than once
RS-232 only
1 short high beep
Bad symbology. Scanned a 1D or 2D bar code in a MPDF sequence,
a duplicate MPDF label, a label in an incorrect order, or trying to
transmit an empty or illegal MPDF field.
Flushing MPDF buffer.
Aborting MPDF sequence.
Flushing an already empty MPDF buffer.
Enter another digit. Add leading zeros to the front if necessary.
Enter another alphabetic character or scan the End of Message bar
code.
Enter another criterion or action, or scan the Save Rule bar code.
Rule saved. Rule entry mode exited.
All criteria or actions cleared for current rule, continue entering rule.
Delete last saved rule. The current rule is left intact.
All rules are deleted.
Out of rule memory. Erase some existing rules, then try to save rule
again. (It is not necessary to re-enter the current rule.)
Cancel rule entry. Rule entry mode exited because of an error or the
user asked to exit rule entry.
Entry error, wrong bar code scanned. Re-enter criterion or action. All
previously entered criteria and actions are retained. Criteria or action
list is too long for a rule.
Digital scanner did not complete initialization. Wait several seconds
and scan again.
Communication with the bus must be established before the digital
scanner can operate at the highest power level.
The USB bus can put the digital scanner in a state where power to
the digital scanner is cycled on and off more than once. This is
normal and usually happens when the PC cold boots.
A <BEL> character is received and Beep on <BEL> is enabled.
Scanning
Indication
2 - 3
Advertisement
Table of Contents
