User Preferences Parameter Defaults - Motorola Symbol DS6607 Product Reference Manual

4-4 Symbol DS6607 Product Reference Guide

User Preferences Parameter Defaults

Table 4-1 lists defaults for user preferences parameters. There are two ways to change the default values:
• Scan the appropriate bar codes in this guide. These new values replace the standard default values in memory. To recall the
default parameter values, scan the
• Download data through the device's serial port using SSI. Hexadecimal parameter numbers are shown in this chapter below
the parameter title, and options are shown in parenthesis beneath the accompanying bar codes. See the Simple Serial
Interface (SSI) Programmer's Guide for detailed instructions for changing parameters using this method.
See Appendix A, Standard Default Parameters
miscellaneous default parameters.
Note
User Preferences
Set Default Parameter
Parameter Scanning
Beeper Tone
Beeper Volume
Power Mode
Time Delay to Low Power Mode
Trigger Mode
Picklist Mode
Decode Session Timeout
Timeout Between Decodes, Same Symbol
Beep After Good Decode
*Set All Defaults bar code on page 4-5.
for all user preferences, hosts, symbologies, and
Table 4-1. User Preferences Default Table
Parameter
Parameter
Number Default
All Defaults
ECh Enable
91h Medium
8Ch High
80h Continuous On
92h 1 Minute
8Ah Auto Aim
F0h 92h Disabled Always
88h 9.9 Sec
89h 0.6 Sec
38h Enable
Page
Number
4-5
4-5
4-6
4-7
4-7
4-8
4-10
4-11
4-11
4-12
4-12