Chapter 5 Imaging Preferences; Introduction - Motorola Symbol DS3407 Product Reference Manual

Chapter 5 Imaging Preferences

Introduction

You can program the digital scanner to perform various functions, or activate different features. This chapter
describes imaging preference features and provides programming bar codes for selecting these features.
The digital scanner ships with the settings shown in the
Appendix A, Standard Default Parameters
requirements, programming is not necessary.
To set feature values, scan a single bar code or a short bar code sequence. The settings are stored in non-volatile
memory and are preserved even when you power down the digital scanner.
NOTE Most computer monitors allow scanning the bar codes directly on the screen. When scanning from the
screen, be sure to set the document magnification to a level where you can see the bar code clearly, and
bars and/or spaces are not merging.
Select a host type (see each host chapter for specific host information) after the power-up beeps sound. This is
only necessary upon the first power-up when connected to a new host.
To return all features to default values, scan
code menus, asterisks (
*
Indicates Default
for all host device and miscellaneous defaults). If the default values suit
Set Default Parameter on page
*
) indicate default values.
*Enable Decode Aiming Pattern
Imaging Preferences Default Table on page 5-2
4-4. Throughout the programming bar
(02h)
(also see
Feature/Option
Option Hex Value for
programming via SSI
command