Radio System Installation
Required Parts
• Fuselage assembly
• Receiver battery
• Tie wraps
Required Tools and Adhesives
• Hobby knife
Step 1
Mount the radio system inside the fuselage. Make sure
the radio is protected from vibrations from the fuselage by
using foam at any contact points between the radio system
and fuselage.
28
• Receiver
• Foam
• Y-harness
Step 2
Mount radio switch (or switches) in the rear switch holes
and the ignition switch in one of the front switch holes.
Note: There are three switches on the plane.
The ignition is right behind the firewall and
the other two are above the receiver. We used
dual batteries so there are two switches for
the radio system. We plugged one switch
into the battery port on the receiver then used
a Y-harness off of any other channel and
plugged the other switch into the Y-harness.