Hangar 9 85cc Sukhoi SU-26MM Assembly Manual page 22


Step 8
Attach the throttle linkage to the carburetor using a
2mm x 4-40 ball link 2mm x 10mm socket head screw
and 2mm lock nut.

Step 9
With the throttle servo and linkage in the closed position,
use a felt-tipped pen to mark the linkage where it crosses
the outer hole on the servo arm.
22

Step 10
Bend the pushrod wire 90-degrees at the mark made in
the previous step. Use a pin drill and 3/32-inch (2.5mm)
drill bit to enlarge the outer hole of the servo arm.

Step 11
Secure the pushrod wire to the servo arm using a
pushrod connector. Snap the connector on the pushrod
wire to secure.