Aileron Servo Installation - Hangar 9 85cc Sukhoi SU-26MM Assembly Manual

Aileron Servo Installation

Required Parts
• Wing panel (left and right)
• 4-40 x 4-40 ball end w/hardware (2)
• Control horn (2)
• 3-inch (76mm) linkage (2)
Required Tools and Adhesives
• Phillips screwdriver
• Ruler
• Hex wrench: 3/32-inch
• Servo extension, 24-inch (610mm) (2)
1
• 1 / -inch Single Side Alum Adj.
2
Spline Servo Arm (2)
 
Step 1
Attach a 24-inch (610mm) servo extension to the aileron
servo. Secure the extension using a commercially
available connector, heat shrink tubing or string so it will
not unplug inside the wing.
 
Step 2
Tie a weight to a piece of string. Lower the weight into the
opening for the aileron servo.
8
• Nut driver: 1/4-inch
• String w/weight
 
Step 3
Tip the wing so the root is facing down and lower the
weight through the wing.
 
Step 4
Tie the string to the servo extension.