Table of Contents
Advertisement
4
Fit the supplied threaded pins in the retaining brackets beforehand.
Fig. 40 Threaded pin pre-fitted in a retaining bracket
5
Fit the device from the front into the mounting cutout.
6
Clip on the retaining brackets in the recesses provided for them on the device as shown below and
fix the device by tightening the threaded pins until the front of the MICRO PANEL is flush with the
surface of the control cabinet.
CAUTION
Mechanical damage to the device
Tightening the threaded pins too tightly may damage the device.
Tighten threaded pins with a max. tightening torque of 0.2 Nm.
The positions of the retaining brackets depend on:
the size of the device and
the mounting requirements.
10.4" and 12.1" devices (standard mounting):
Top and bottom of the device:
Fit one retaining bracket each at the left and right fixing position
Fig. 41 10.4" and 12.1" devices with four retaining brackets (do not meet IP65 requirements)
MICRO PANEL XV400 10.4"/12.1"/15" 12/2010 MN04802010Z-EN www.eaton.com
5 Installation
5.4 Mounting
51
Advertisement
Table of Contents
