Ethernet - Eaton XV400 10.4" Operating Instructions Manual

5 Installation
5.3 Cable preparation
5.3.5
Cable
34

Ethernet

Conditions for use in an end-product (according to Underwriters Labaratories Inc. (UL)):
In order to protect the device from potential internet threats, it should be connected to Ethernet

networks that are isolated from the internet or safety protected and isolated from the Corpo-
rate/Enterprise network by a firewall or router.
Fig. 16 Ethernet interface (RJ45 socket)
LED Signal
ACT (yellow) flashes
LINK (green) lit
Tab. 15 Control LEDs of the Ethernet interface
Use shielded twisted pair cable (STP) for networking:

For device to device connection: crossover cable

For connecting to the hub/switch: 1:1 patch cable

Maximum cable length: 100 m.

Ethernet interface in accordance with EIA/TIA 568 TSB-36.
CAUTION
Forces acting on the Ethernet interface
Communication can be disturbed and the connection mechanics damaged if the
Ethernet interface is exposed to severe vibration or the RJ45 plug connection is
pulled.
Protect the RJ45 connection from severe vibration.

Protect the RJ45 connection from pulling on the socket.

MICRO PANEL XV400 10.4"/12.1"/15" 12/2010 MN04802010Z-EN www.eaton.com
LINK ACT
Meaning
Ethernet is active (data traffic)
Active network is connected and detected