Table of Contents
Advertisement
410.0
+1/-1
430.0
+0.2/-0.2
Fig. 33 Mounting cutout for 15" devices
3
Mounting the front seal:
Fig. 34 Front seal fitted
A Countersunk screw
3.1
Fit the countersunk screws in the corresponding holes of the device front plate.
3.2
Place the device face down with the countersunk screws.
3.3
Pull off the protective foil from the supplied front seal.
3.4
Fit the front seal with the adhesive side face down onto the rear of the front plate and press
it down.
4
Fit the device from the front into the mounting cutout.
CAUTION
Poor sealing
Poor sealing resulting from inaccurately positioned front seal.
Ensure that the front seal is flat and fitted evenly between the front plate of the
device and the mounting surface.
MICRO PANEL XV400 10.4"/12.1"/15" 12/2010 MN04802010Z-EN www.eaton.com
B Front seal
5 Installation
5.4 Mounting
47
Advertisement
Table of Contents
