Easy Checker (Tm); Engine Overheating Precautions; Fuel Gauge - Kubota GR1600-ID-2 Operator's Manual

BEasy Checker (TM)
If the warning lamps in the Easy Checker(TM) come on
during operation, stop the engine immediately, and find
the cause as shown below.
Never operate the machine while Easy Checker(TM) lamp
is "ON".
: Engine oil pressure
If the oil pressure in the engine goes below the
prescribed level, the warning lamp in the Easy
Checker(TM) will come on.
If this should happen during operation, and it does
not go off when the engine is accelerated to more
than 1000 min (rpm), check the level of engine oil.
(See "Checking Engine Oil Level" in "DAILY CHECK"
in "PERIODIC SERVICE" section.)
: Electrical charge
If the alternator is not charging the battery, the warning
lamp in the Easy Checker(TM) will come on.
If this should happen during operation, check the
electrical charging system or consult your local
KUBOTA Dealer.
: Coolant temperature
If this warning light comes on during operation, take
the actions according to "Checking and Cleaning
Radiator to Prevent Overheating".
: Glow plug Indicator (Pre-heating Indicator)
When the key switch is in the "PREHEAT" position, the
glow plug indicator illuminates.
A For checking and servicing of your machine, consult
your local KUBOTA Dealer for instructions.
BEngine Overheating Precautions
If the coolant temperature warning light come on or the
buzzer sounds, take the following actions.
1. Stop machine operation in a safe place, disengage the
mower deck and keep the engine idling.
2. Don't stop the engine immediately; stop it after about
5 minutes of unloaded idling.
3. Shut off the engine and keep well away from the
machine for 10 minutes or while the steam is blown
out.
4. Checking that there is no danger of being burned, get
rid of the causes of overheating according to the
manual, see "TROUBLESHOOTING" section.
Start the engine again.
OPERATING THE MACHINE
BFuel Gauge
The fuel gauge indicates the fuel level.
Be careful not to empty the fuel tank. Otherwise air may
enter the fuel system.
If this should happen, the fuel system should be bled.
(See "SERVICE AS REQUIRED"
SERVICE" section.)

(1) Fuel gauge

A Use proper fuel for your machine, or it damages the
machine.
GR1600-ID-2: Diesel fuel
A Do not refuel over "F". Fill the tank only to the bottom
of the filler neck in the fuel tank.
21
in "PERIODIC
(E) "EMPTY"
(F) "FULL"