Fuji Xerox ApeosPort-V C5575 User Manual page 154

3 Copy
Important • Ensure that the actual orientation of the original document matches the [Original Orientation]
Hole Punch
Sets the position for punching.
3
The positions for punching vary depending on a finisher installed.
The C3 Finisher and C3 Finisher with Booklet Maker offer nine different punch positions: 2
Holes, 2 Holes Top, 2 Holes Right, 3 Holes, 3Holes Top, 3Holes Right, 4 Holes, 4 Holes Top, 4
Holes Right.
Important • When the punching feature of a finisher is defective, output is delivered to the center tray instead of
Original Orientation
Allows you to specify the orientation of the document so that the machine can identify the
top of the document.
Note
Z Fold Half Sheet
The machine folds the output copies in Z fold. Z fold can be applied to B4, A3, 11 x 17". If
you have mixed sized documents, the width (vertical direction) of the paper must be the
same, such as a combination of A4 (portrait) and A3 (landscape), and a combination of B5
(portrait) and B4 (landscape). For example, if you have a combination of A4 (portrait) and
A3 (landscape), the Z fold is only applied to A3.
Output Destination/Offset
Allows you to select the output destination tray and offset operation.
Note
154
Bond, Plain, Recycled, Plain Reload, Lightweight, Heavyweight, Heavyweight Reload,
Extra Heavyweight, Extra Heavyweight Reload, Punched, Gloss, Gloss Reload,
Heavyweight Gloss, Heavyweight Gloss Reload, and Custom Paper 1 to 5.
C3 Finisher/C3 Finisher with Booklet Maker
Bond, Plain, Recycled, Plain Reload, Lightweight, Heavyweight, Heavyweight Reload,
Extra Heavyweight, Extra Heavyweight Reload, Punched, Gloss, Gloss Reload,
Heavyweight Gloss, Heavyweight Gloss Reload, and Custom Paper 1 to 5.
setting on the [Layout Adjustment] screen.
In the following cases, the actual stapling position differs from the stapling position displayed on the
screen:
- When [Original Orientation] is set to [Upright Images], and [Staple] is set to one position at the
right side.
- When [Original Orientation] is set to [Sideways Images], and [Staple] is set to one position at the
left side.
the finisher tray. Remove the output delivered to the center tray every now and then.
• Ensure that the actual orientation of the original document matches the [Original Orientation]
setting on the [Layout Adjustment] screen.
• If the [Original Orientation] setting differs from the actual document orientation, the machine may
not detect the top of the document correctly.
Upright Images
Select this option when placing the top edge of the document against the top side of the
document glass or document feeder.
Sideways Images
Select this option when placing the top edge of the document against the left side of the
document glass or document feeder. Always select [Sideways Images] when the top of
the document is placed facing the left side (horizontal text).
Offset Stacking
• This feature does not appear for some models. An optional component is required. For more
information, contact our Customer Support Center.