hsr-benelli S-series Service Manual page 81

Rotate the engine 180° to be placed on its bottom side.
Tighten the bolt under roll-over valve in two phases (shown
in oval-mark)
Tightening torque:
st phase: 10 N·m (1,0 Kg-m)
1
nd phase: 25 N·m (2,5 Kg-m)
2
Tighten five screws (shown in circle-marks) with specified torques:
Tightening torque: 10 N·m (1,0 Kg-m)
Install Oil pump cover and tighten its screws with specified
torque:
Tightening torque: 10 N·m (1,0 Kg-m)
Install roll-over valve assembly and tighten its fasteners
with a specified torque.
Tightening torque: 10 N·m (1,0 Kg-m)
ver.2009_03 Page 81/215