Periodic Maintenance Procedures; Oil Level Check - hsr-benelli S-series Service Manual

2.3 Periodic maintenance procedures

2.3.1 Oil level check

NOTE:
Use a clean, lint-free cloth
PWC must be leveled to perform oil level verification. Check
the oil level when engine is cold by pulling the oil dipstick out
of the engine. The oil level must be within the minimum and
maximum marks. When engine is warm proceed the same
way but insure your check is done five minutes after engine is
stopped to enable the remaining oil to go back to the bottom
of the engine. Oil level may be higher than at cold engine
since the oil volume increases in warm condition.
WARNING:
Engine oil may be hot.
Note: Engine must be cold
If the valve clearance is out of specifications take note about
your current reading for adjustment.
ver.2009_03 Page 23/215