5.6 Assembling riding plate
Apply blue Loctite 243 on the thread of the screws.
Put in place the Riding Plate and tighten 4 x screws with specified torque.
Tightening torque: 12 Nm.
5.7 Steering cable setting
Hold the steering in straight forward position.
The distance of the jet nozzle to the jet drive outlet
must be the same on the left and the
right side. Otherwise, adjust the steering cable
accordingly.
To disconnect the steering cable from the jet nozzle at the ball joint, you must first pull
the steering cable back. Then, pull up on the connection. The cable will be free from
the connection.
The distance should be the same on both sides. (x)
WARNING:
Pay special attention when assembling components of steering system. Non
proper assembling could result lost of contol during riding vehicle.
ver.2009_03
Page 130/215