Standard Torque Specifications - hsr-benelli S-series Service Manual

RPM LIMITER
EXHAUST SYSTEM
ENGINE MANAGEMENT SYSTEM
FUEL DELIVERY
IDLE SPEED
MAGNETO GENERATOR OUTPUT
BATTERY
FUSES
STARTER
PROPULSION
JET PUMP TYPE
IMPELLER
COUPLING TYPE
MINIMUM DEPH FOR OPERATION
HULL / BODY
HULL MATERIAL

1.4.2 Standard Torque Specifications

The following torque specifications are to be used as a general guideline.
Use standard torque values for the appropriate size fastener when torque values are not
specified.
Always consult the specific manual section for torque values of fasteners and use of
locking agent.
4 mm
5 mm
6 mm
7 mm
10 mm
12 mm
ver.2009_03
9200 – 9300 1/min – Determined by ECU
Waterbox with water injector
WALBRO Multi-point fuel injection
1700 1/min +/- 50
13.5V / 48A at 5000 rpm
Series-R: 12 Volts 20Ah
Series-S: 12 Volts 14Ah
30A – Alternator, 15A – Fuel Pump, 7,5A – Stop switch,
30A - Main
Electric Motor 12V – 850 W
SOLAS – Axial Flow – 12 Veins – Steel stator
Stainless steel – 3 blade
Series-S Pro Edition – 14/25,
Series-S Race Edition – 15/26,
Series-R Naked Edition – 11/19,
Series-R Pro Edition – 11/19 XL
Six piece coupler + Damper
60cm (2 Ft)
Fiberglass, RTM Process
RECOMMENDED TORQUE SPECIFICATION
STAINLESS STEEL FASTENERS (METRIC)
Page 17/215
3 -3,5 NM (40–42 in.lbs.)
4 – 4,5 NM (45-52 in.lbs.)
5,5 – 6,5 NM (66-78 in.lbs.)
17 – 23 NM (13-16 ft.lbs.)
35 – 40 NM (26-30 ft.lbs.)
54 – 60 NM (40-44 ft.lbs.)