Assembly Of The Hanle Bar On The Pwc - hsr-benelli S-series Service Manual

Apply Loctite 243 on the thread of the second steering control bushing and put it in place.
Tighten the system with a torque meter.
Tightening torque: 20 N·m
Take the ball joint screw and apply Loctite 243 on the thread of the screw. Tighten the ball
joint.
Put the Handle bar, clamp and mounting screws in place.
Tighten the screws with a torque meter.
Tightening torque: 20 N·m
9.6 Assembly of the Handle Bar on the PWC
Place on the RIGHT SIDE of PWC: Trim, Dashboard and the
Start Stop switch wire
Place on the LEFT SIDE of PWC: Throttle and Steering cables
Take left two cables for Throttle and Steering and put them
through the handle bar
ver.2009_03 Page 171/215