hsr-benelli S-series Service Manual page 136

Screw in the screws and tighten them with specified torque.
Tightening torque: 5 N·m, in X-method
Leak test of the subassembly of the Fuel Pump/Fuel Tank
Note: Always perform a leak test during fuel tank disassembly/
fuel pump inspection.
Apply a pressure of 0,3 bar into the tank system and check
for loss of pressure with the help a spray test. (see picture)
Release the pressure carefully by opening the fuel cap as
shown in the picture.
ver.2009_03 Page 136/215