Engine Oil And Filter Replacement - hsr-benelli S-series Service Manual

2.3.2 Engine oil and filter replacement

Remove the dipstick.
To suck the oil out with an oil removing pump, put the suction
hose as deep as possible into the engine into dipstick tube.
Suck the oil out of the engine completely.
Take out old oil filter
Before installation of new oil filter, grease filter O-ring slightly
with engine oil.
Install new oil filter and tighten with specified tightening torque.
Open oil filling cap on engine valve cover (shown by arrow).
Refill the engine with new engine oil.
ATTENTION:
ALWAYS USE HSR-BENELLI ENGINE OIL.
NOTE: FOR SERIES-S
Volumes of oil in the engine: min 1,7 litres (without change of oil filter), max 2,0 litres
(change of oil filter included). In case of completely dry engine: 2,3 litres.
Required torque for oil filter cover: 24 Nm
Required torque for ignition coils: 10 Nm
Required torque for spark plugs: 12 Nm
WARNING:
Never fill with more than 2,3 l of oil into the engine (oil filter included).
NOTE: FOR SERIES-R
Volumes of oil in the engine: min 2,1 litres (without change of oil filter), max 2,4 litres
(change of oil filter included). In case of completely dry engine: 2,7 litres.
Required torque for oil filter cover: 24 Nm
Required torque for ignition coils: 10 Nm
Required torque for spark plugs: 12 Nm
WARNING:
Never fill with more than 2,7 l of oil into the engine (oil filter included).
ver.2009_03 Page 24/215