Position the timing chain on the camshaft sprockets.
Position the bridge and the upper chain pad and tighten the fixing screws in two phases in
shown sequence.
Tightening torque:
1st phase: 6 N·m;
2nd phase: 13 N·m
NOTE:
Always oil the sliding parts with Teflon SINTOFLON paste.
Position the chain tensioner (1) complete with O-ring (2) and
tighten two screws (6).
Tightening torque: 10 N·m
Position the rod pushing spring (3) and the washer (4) and
tighten tensoiner cap nut (5).
Tightening torque: 7 ÷ 8 N·m
ATTENTION:
Always check that chain tensioner is in
position 0 before mounting it.
Align the marks on the camshaft sprockets as shown on the
figure.
Count 30 chain pins from position 1 to position 30 as indicated
on the figure.
ver.2009_03
Page 46/215