Trim System Bleeding - hsr-benelli S-series Service Manual

5.8 Trim system bleeding

NOTE: Put protection on the hull to avoid brake liquid contact with the paint of the
hull!
3
Fill an injector like shown in the picture with brake liquid half the way (10 cm ) and screw a
bleeding nipple into the trim system. Put covering material on the PWC in order to protect the
paint of the deck.
Attach the Injector with a hose and tighten it with a plastic clamp.
Press the injector 10 times.
Put the nozzle in top position and repeat the injector pump process 10 times.
Put the nozzle in bottom position and repeat the injector pump process 10 times.
ver.2009_03 Page 131/215