Center Flange Bearing - hsr-benelli S-series Service Manual

4.3 Center flange bearing

Assembly of the flange bearing:
Grease the oil seal lips with water resistance grease on both sides.
RECOMMENDED LUBRICANT:
FUCHS URETHYN E/M 2
Use new pre-coated screws or apply blue Loctite 243
Put in place the flange bearing and tight
4 screws with specified torque.
Support the bearing with a hammer to put
the bearing on the top position.
Tightening torque: 30 N·m
ver.2009_03 Page 107/215