Jet Pump Assembly Into The Pwc - hsr-benelli S-series Service Manual

5.4 Jet Pump Assembly into the PWC

Grease the sealing lips of the jet pump.
Assemble the Flange bearing with it`s 4 screws into the rear of jet pump tunnel. Apply blue
Loctite 243 on the threads of the screws or take new micro coated screws.
Support the Flange bearing during assembly with a hammer to pull it on the top position
during tightening.
Tighten the screws with specified torque.
Tightening torque: 30 N·m, in X-method
ver.2009_03 Page 127/215