Changing The Name Of A Route; Creating An Olympic Route - Standard Horizon CP590 Owner's Manual

At this point the Route is saved as ROUTE01. If you would like to save the Route under a specific
name follow the next steps.
9.1

CHANGING THE NAME OF A ROUTE

To name the Route:
1. Place the ShuttlePoint knob on the Route (on Waypoint or on leg) and press [E
2. Move the ShuttlePoint knob to highlight NAME and press [ENT]. A popup window will
be shown.
3. Move the ShuttlePoint knob up/down to change the characters and left/right to select
a different character in the Routes Name.
4. When finished press [ENT] to save.
5. Press [CLR] to show the Chart page.
9.2

CREATING AN OLYMPIC ROUTE

This feature allows the starting point in a Route to be saved as the final destination point.
1. On the Chart page move the ShuttlePoint knob to the Lat/Lon of the starting Waypoint
in the Route.
2. Press [ROUTE], the starting Waypoint will be placed under the cursor.
3. Move the ShuttlePoint knob to the second Lat/Lon of the next leg in the Route.
4. Press [ROUTE]. Another Waypoint is shown under the cursor and a line joins the
starting Waypoint to the second Waypoint.
5. Repeat steps 3 and 4 until all Waypoints are entered into the Route.
Page 68
NOTE
ROUTE REPORT
Figure 9.1 - Edit Route (Route Report)
Figure 9.2 - Olympic Route creation (1)
WAAS 3D
].
DIT
CP590