Table of Contents
Advertisement
12.0.1 Single Chart Page
1
Time
2
Speed Over Ground
3
Course Over Ground
4
Fix status
Time To Go
5
(If plotter is not navigating to a
point
TTG
will show --:-- )
Distance from Fix to Destination
6
(If plotter is not navigating to a
point DST will show ---.- )
Bearing from Fix to Destination
7
(If plotter is not navigating to a
point BRG will show --- )
8
Chart Scale
12.0.2 Window Selections
The default is the Two Line Small window. The CP590 windows may be changed by the
procedure below.
FULL CHART (None)
2 LINES SMALL
02:00
1. To change, press [MENU], move the ShuttlePoint knob to highlight SETUP MENU and
press [ENT].
2. Move the ShuttlePoint knob to highlight GENERAL SETUP and press [ENT].
3. Move the ShuttlePoint knob to highlight WINDOW SETUP and press [ENT].
4. Move the ShuttlePoint knob to highlight CHART PAGE and press [ENT].
5. Select the desired window, HIGHWAY or COMPASS, and press [ENT].
6. Press [CLR] or move the ShuttlePoint knob to exit the menu and show the Chart page.
12.0.3 Customizing the Data Windows
The data fields contained on the General, 1 Line Small/Large and 2 Line Small data windows
Page 84
5
6
9
10
o
Figure 12.0.1 - Example of single Chart Page
GENERAL
WAAS 3D
HIGHWAY
WAAS 3D
Figure 12.0.2 - Data window layout
1
2
9 Cursor Coordinates
10
Distance & Bearings from Fix to Cursor
1 LINE SMALL
WAAS 3D
COMPASS
WAAS 3D
3
4
WAAS 3D
8
7
1 LINE LARGE
WAAS 3D
CP590
Advertisement
Table of Contents
