Goto Cursor, Route And Mark - Standard Horizon CP590 Owner's Manual

7.4

GOTO CURSOR, ROUTE AND MARK

The GPS Chart Plotter can easily be set to start navigating to the Cursor on the chart page,
a saved Mark or a Route that was created.
GOTO CURSOR
1. Move the ShuttlePoint knob to the exact position you want to navigate to.
2. Press [GOTO] and a GOTO popup window will be shown.
3. Move the ShuttlePoint knob to highlight CURSOR and press [ENT].
4. The GPS Chart Plotter is now navigating from your current position to the location
selected at step 1. A bearing line between the vessels location and the destination point
is shown. A popup window shows the Distance (DST) and Bearing (BRG) from the
vessels location to the destination point.
CP590
Figure 7.4 - GO TO menu (1)
Figure 7.4a - GO TO menu (2)
Figure 7.4b - GO TO menu (3)
Page 63